Thanks Beary Much Card Instructions
See photo of card (click photo for larger view):
back:
front: 
inside: 
inside with flash:
I'm going to
TRY ;) and remember every tool and product used.
Front
On the front I used Cock-A-Doodle
Design, Inc.'s Page Frames and die-cuts, page protector cut to
size, Gelly Roll pen XPGB#719, Miller Studio Inc. Mounting tape,
Hermie, 81/2 x 11 card stock (cut down to fit frame), sticky dots,
baby powder, paint brush, Fiskars® 12" trimmer and micro-tip
sissors, one of those squares to remove adhesive...can't remember
what they are called
Shaker pieces: Dress It Up (a
Jesse James Company) miniature heart collector whipstitched, clear
Rochaille beads, red beads.
Inside
Pop Dots, Cock-A-Doodle Design,
Inc's die-cut, terrifically tacky tape, clear marbles, Gelly Roll
pen XPGB#719, Fiskars® heart corner punch/rounder
Back
stampcraft stamp 440D33, Dauber
Duos DD-51 UM Blue, Gelly Roll pen 37359, Fiskars® heart corner
punch/rounder
INSTRUCTIONS:
Front:
trim largest Cock-A-Doodle Design,
Inc.'s Page Frame to 5 ½ inches. Making sure to trim equal
amounts off each side. Trim card stock to length of largest frame.
The paper will be creased to 5 ½ inches so that the 8 ½
inch by 11 inch paper will be folded in half. Hermie the large
frame to what will be the front of the card(stock). Hermie die
cuts and add to middle being careful they will be seen through
the smaller frame. Add any written sentiments at this time.
Take the small size Cock-A-Doodle
Design, Inc.'s Page Frame and Hermie the back (wrong side). Cut
page protector to fit site of opening overlapping somewhat but
not larger than the outside of the frame and add to the back side
of the frame. Cut foam tape to fit the edges of the frame. Place
it in the middle so it won't be seen easily when finished. Depending
on the size of your embellishments inside the shaker you may need
to make more layers of the foam tape. I used three rows. When
the last row is on don't remove the protective paper. Use baby
powder and a paint brush to brush the baby powder on the inside
of the foam tape. This is to keep your embellishments from sticking
to the tape when it's shaken. When you're done tap the frame on
the side to remove extra powder. After all is removed a damp cloth
will remove any left on page protector. Remove enough of the tape's
protective paper that you will have a U shape of exposed adhesive.
Place frame in the center of the large frame. Pull lightly to
open the top and add your embellishments then pull the remainder
of the tape's protective paper off. Keep upright so the embellishments
stay inside.
Inside:
Cut terrifically tacky tape to
cover die cut and then add marbles. Attach to the left side of
the opened card with pop dots. Write sentiment on right side of
card. Use Fiskars® heart corner punch/rounder on right side
of open card corners.
Back:
Stamp "hand made by"
with blue dauber duo and sign name with Gelly Roll pen 37359.
Since I made a boo-boo on the back I cut a piece of matching card
stock and made a "tag" to go over the boo-boo. I used
the Fiskars® heart corner punch/rounder to make it look like
I intended to have a tag there. I filled in some of the hearts
with the Gelly Roll pen 37359.
Back
to Lay outs Page
| 
